FAQ 20 Channel MP3 Sound Board with 2x15W Amplifier (FN-BC20)

Q1: How do I adjust the volume of the board?

A1:  All you need is a small  small screwdriver. You can adjust the volume on board separately for the left channel and for the right channel. After changing the volume, a power cycle (on-off-on) is required for the change to take effect. 

(Note on version 1.1 of the board the volume control is anti-clockwise for volume up.  opposite of the usual convention. On units sold since early 2018 this problem were fixed. Volume up is now clockwise )

Q2: I changed the trigger mode via DIP switches, but new trigger mode did not take effect (Version1 of the board)

A2:  All changes must have a power cycle to take effect. (on-off-on). The factory default triggering mode is “pulse interruptible". After you shift to another triggering mode, you need to power cycle the board on-off-on, then the new settings will be executed.
(Version 1.1 of the board use a read.cfg file to change the trigger modes)

Q3: What bit rate must the MP3 file be?

A3:  The module supports bit rates of 32 Kbps, 64 Kbps, 96 Kbps, 128 Kbps, 256 Kbps and 320Kbps for MP3 files. Other bit rates for MP3 files could cause problems with playback.

Q4: What sampling rate must the .WAV file be?

A4:  The module supports sampling rates of 8 / 11.025 / 12 / 16 / 22.05 / 24 / 32 / 44.1 or 48 KHz for .WAV files. Other sample rates for .WAV files could cause problems with playback.

Q5: I used an Apple Mac to copy the sound files to the MicroSD card or onboard flash memory. Now not all of the buttons play a sound when activated

A5:   We found that some versions of the MacBook hide some of the files when they are copied to the microSD card or onboard flash memory. Solution is to reformat the microSD card or onboard flash memory, using a Windows computer and then copy the sound files to the microSD card or onboard flash memory using a Windows computer. 

Q5: I copied my sound files to the SD card, but it doesn't play any of them back

A5:   Make sure you followed the naming conventions for the files and folders as explained on page 5 and 6 here: Manual.  Also make sure your folders are named 01, 02, 03... and not 001, 002, 003 etc.

 

Q6: I changed the configuration file to a new trigger mode. The default trigger mode is still used, instead of the new trigger mode.

A6: Make sure your computer is not set to hide the file extensions. Your file is incorrectly named "read.cfg.txt" instead of "read.cfg". Uncheck "hide extensions for known file types" under "folder options" and rename your config file to "read.cfg"


Q7: I put the files into the SD card, but they still wont play.

A7: If your sound files are named properly and still not playing, move them into a folder. For button 1 create a folder named "01" and move the sound file into that folder.  For button 2 create a folder named  "02" and then put the sound file into that folder , and so on.

To view the full filename make sure that "Hide extensions for known file types" is unchecked under "folder options"
Odoo text and image block